Electric Tricycle Controller Quotes
Introduction to the controller Briefly speaking, the controller is composed of peripheral devices and the main chip (or single-chip microcomputer). The design quality and characteristics of the controller, the function of the microprocessor used, the circuit of the power switch device and the layout of peripheral devices, etc., are directly related to the performance and operating status of the vehicle, and also affect the performance and efficiency of the controller itself. Controllers of different quality, used in the same vehicle and equipped with the same set of batteries in the same charge and discharge state, sometimes show great differences in driving ability. Peripheral devices are some functional devices, such as execution, sampling, etc. They are resistors, sensors, bridge switch circuits, and devices that assist single-chip microcomputers or application-specific integrated circuits to complete the control process; single-chip microcomputers are also called microcontrollers. A memory, a decoder with a signal language conversion, a sawtooth wave generator and a pulse width modulation function circuit, and the power tube of the switching circuit can be turned on or off, and the conduction time of the power tube can be controlled by a square wave to control the motor speed. The drive circuit, input and output ports, etc. are integrated together to form a computer chip. This is the smart controller for electric bikes. It is a high-tech product in the form of a 'fool'. The type of controller At present, the controller circuit principle used by electric bicycles is basically the same or similar. Most of brushed and brushless DC motors use the PWM control method of pulse width modulation to control the speed, but the difference in the selection of driving circuits, integrated circuits, switching circuit power transistors and some related functions. Differences in components and circuits make up the difference in controller performance. The controller is divided into two types in structure, we call it separate type and integral type.
Separation The so-called separation means that the main body of the controller and the display part are separated, the latter is installed on the handlebar, and the main body of the controller is hidden in the car body box or electric box, and is not exposed outside. In this way, the distance between the controller, the power supply and the motor is shortened, and the appearance of the car body is simple. The box is installed in the center of the handlebar, and the panel of the box has a number of small holes with a diameter of 4~5mm, and a transparent waterproof membrane is applied outside. There are light-emitting diodes in the corresponding positions of the holes to indicate the speed of the vehicle, the power supply and the remaining power of the battery. The one-piece control part is integrated with the display part and is housed in a delicate special plastic box.
custom electric bicycles has become a standardized way of dealing with custom electric bike.
Mainbon is the vital link in the supply chain, adding value with efficient and cost-effective service and solutions for our customers and our suppliers.
People are more likely to listen to an expert than just anyone off the street. So, while pack mentality is important, having a relevant expert speak to the effectiveness of a brand's product as Mainbon is essential to converting new consumers as well.
These custom electric motorcycle custom electric bicycles are not only useful but also more cost effective than those traditional ones.